How to Reduce Downlight Hole Size [Step-by-Step]

Hmmm, so, you are not satisfied with your current downlight size, want to downgrade, and don’t have a clue how to reduce the downlight hole size?

Well, in case, it rings bells, then you have landed on the right blog post.

In this article, we have provided you with a complete step-by-step guide, which you can follow to effectively reduce the downlight hole size.

That being said, let’s jump straight into the matter, and check out the details.

Tools Required for Decreasing the Downlight Hole Size

• Gloves
• Goggles
• Mask
• Downhole Reducer

Steps for Reducing the Downlight Hole Size

The steps for reducing the downlight hole size are a little different from making a new downlight hole or enlarging an existing downlight hole.

Instead of cutting a new hole, or enlarging an existing hole with a drill, you need to use the downlight hole reducer plate to reduce the size of the downlight hole and fit a new downlight with reduced size.

Below, we have provided you with all the steps for reducing the downlight hole size.

Step.1: Gather All the Equipment

Before you begin the actual procedure for the reduction of the downlight size, you need to gather all of your safety equipment. You need to wear the protective glasses, put on your mask, as well as the protective gloves. Most important of them all, you need to get the right-sized hole reducer, and you are good to move on to the next step.

Step.2: Do All the Safety

After wearing the safety equipment, you also need to do your other safety procedures as well. You need to turn off the electrical breaker/FUSE. Also, you need to thoroughly check out the other stuff like the joists, and any other fixtures from the ceiling as well.

When you have finally done all the safety precautions, it’s time to move on to the next steps and continue the procedure.

Step.3: Remove the Existing Downlight

Now, that you have done all the safety stuff, it’s time to remove the existing downlight from the fixture. First of all, you need to remove the downlight, and then remove the wires from the downlight. For the sake of safety, you need to put electrical insulation tape on the wires.

Step.4: Ultimately Fit the New Downlight Reducer Hole

Finally, you need to put the new downlight reducer hole into the existing hole, and now you have successfully reduced the size of the downlight hole. According to the type of the downlight reducer, you need to use plaster in some sort of downlight reducers, and others don’t require it.

Frequently Asked Questions (FAQs)

Is It Possible to Reduce the Downlight Hole Size?

Yes, it is possible to reduce the downlight hole size. Above, we have provided you with a complete step-by-step guide that you can follow to reduce the downlight hole size.

Do We Need Any Sort of Special Tool for Reducing the Downlight Hole Size?

Yes, you need to use the downlight hole reducer in order to fix the downlight. The Downlight hole reducer is a tool that can be used for reducing the downlight hole size.

Is It Worth Reducing the Size of the Downlight?

It totally depends upon your requirements, if you want to change the lighting order, then you can reduce the size of the downlights. Reducing the downlight size can be a little tricky, thus, we have provided you with a step-by-step guide that you can follow to reduce the size of the downlight.

Conclusion

In order to fit the smaller-sized downlights into the existing downlight hole, you need to make the downlight hole smaller by reducing its size.

Reducing the downlight size can be a little difficult, but not impossible. Above, we have provided you with complete steps that you need to follow in order to reduce the downlight hole size.

Were you able to reduce the downlight hole size using our guide? Let me know in the comments section below, we would love to hear from you.